Details
Most rearview mirror adhesive kits have a primer (hardener) that comes in a spray can. With the spray primers you typically run out of primer long before you run out of the adhesive due to overspray. And of course, without the primer the adhesive will not harden. This is no longer a problem with our KlingOn™ Rearview Mirror Adhesive Kit which comes with a small brush that is attached to the inside cap of the primer bottle. With the brush you can apply only the amount of primer that’s needed (which is a small amount) instead of wasting. To use KlingOn™, clean the glass and mirror bracket thoroughly. Brush the primer on the glass where the bracket will be installed and then brush the primer on the mirror bracket. Let the primer dry then apply two drops of the adhesive to the bracket. When you are ready to install the rearview mirror bracket, be careful to place it exactly where you want it. HINT: Most technicians mark on the outside of the glass to guide correct placement of the bracket since removal can be almost impossible after you have attached it. Each KlingOn™ Rearview Mirror Adhesive Kit comes with 1-.5 Fluid Oz. Bottle of Rearview Mirror Adhesive and 1-.5 Fluid Oz. Bottle of Primer, all in a box that can also be convienently used as a bottle holder.
Additional Information
SKU | KMK630 |
---|